Install Silent Brick Controller G-Series
Install rack rails
Disassemble rack rails
The rack rails must first be disassembled into two parts. To do this, proceed as follows:
➤ Pull the inner rail out of the outer rail until the release lever (32) is visible.
Fig.: Pulling out inner rack rails
➤ Operate the release lever (32).
➤ Pull the inner rail completely out of the outer rail.
Fig.: Release lever
Mount inner rack rails to the controller/shelf
To mount the inner rack rails to the controller/shelf, proceed as follows:
➤ Position the inner rack rail onto the side housing of the controller/shelf so that the locking pins of the controller/shelf fit into the locking eyes of the rail.
➤ Push the rail forward until it clicks into place.
Fig.: Locking rack rails
➤ Secure the rails on both sides with one of the included M4×4 screws to the housing.
Fig. Screwing in rack rails
Mounting outer rack rails in the rack
➤ To mount the outer rack rails in the rack, proceed as follows:
➤ Slide the safety mechanism (33) of the rail back.
➤ Hook the rail into the rack.
Fig.: Safety mechanism
➤ Release the safety mechanism.
➤ Ensure that the rectangular locking pins are correctly anchored in the rack holes.
Fig.: Locking pin
➤ Screw the rack rail to the front side of the rack with the locking pin.
Fig.: Locking pin
➤ Screw the rack rail to the back side of the rack with the locking screw.
Fig.: Locking screw
Insert controller/shelf into rack
To insert a controller/a shelf into a rack, proceed as follows:
➤ Pull the outer rack rails as far out of the rack as possible.
Fig.: Pulling out rack rails
➤ Hang the device in such a way that the inner rack rails slide into the outer rack rails.
➤ Slide the device into the rack until it stops.
Fig.: Inserting the device
➤ Operate the release lever.
Fig. Release lever
➤ Slide the device into the rack until the locking mechanism engages.
Fig.: Locking mechanism