Skip to main content
Skip table of contents

Configure notifications

Configure notifications

In the 'Notifications' section, you can configure the notification settings.

To configure the notification settings, proceed as follows:

  • ➤ Click the “Edit” button in the “Notifications” section.

  • ➤ The “Notification Settings” window will open.

  • ➤ Enter an IP address or server name for the mail server.

  • ➤ If authentication is required to log in to the mail server, select the “SMTP Authentication” option.

  • ➤ If a secure connection is supported, select the “Use SSL/TLS” option and enter a username and password.

  • ➤ Use the “Sender Email Address” field to specify the address from which the Silent Brick System sends.

  • ➤ To send an email to the FAST LTA Monitoring Service, select the “Email to FAST LTA Monitoring Service” option.

  • ➤ If an email is to be sent to a list of specific email addresses, select the option “Email to address list below.”

  • ➤ Then enter the email addresses to which the email should be sent.

  • ➤ If you wish to add additional information to each message, complete the field "Custom Message."

  • ➤ To modify the time for sending the daily status report, use the section "Daily Status sending.”

  • ➤ To save your entries, click the button “Save.”

  • ➤ To save your entries and send a test email, click the button “Save and Send Test Mail.”

  • ➤ To cancel the operation, click the button “Cancel.”

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.