Install Silent Brick Controller G-Series

Install rack rails

Disassemble rack rails

The rack rails must first be disassembled into two parts. To do this, proceed as follows:

• ➤ Pull the inner rail out of the outer rail until the release lever (32) is visible.

Fig.: Pulling out inner rack rails

• ➤ Operate the release lever (32).

• ➤ Pull the inner rail completely out of the outer rail.

Fig.: Release lever

Mount inner rack rails to the controller/shelf

To mount the inner rack rails to the controller/shelf, proceed as follows:

• ➤ Position the inner rack rail onto the side housing of the controller/shelf so that the locking pins of the controller/shelf fit into the locking eyes of the rail.

• ➤ Push the rail forward until it clicks into place.

• ➤ Secure the rails on both sides with one of the included M4×4 screws to the housing.

Mounting outer rack rails in the rack

• ➤ To mount the outer rack rails in the rack, proceed as follows:

• ➤ Slide the safety mechanism (33) of the rail back.

• ➤ Hook the rail into the rack.

• ➤ Release the safety mechanism.

• ➤ Ensure that the rectangular locking pins are correctly anchored in the rack holes.

• ➤ Screw the rack rail to the front side of the rack with the locking pin.

• ➤ Screw the rack rail to the back side of the rack with the locking screw.

Insert controller/shelf into rack

To insert a controller/a shelf into a rack, proceed as follows:

• ➤ Pull the outer rack rails as far out of the rack as possible.

• ➤ Hang the device in such a way that the inner rack rails slide into the outer rack rails.

• ➤ Slide the device into the rack until it stops.

• ➤ Operate the release lever.

• ➤ Slide the device into the rack until the locking mechanism engages.

Fig.: Locking mechanism