Overview
Silent Cubes
Version: 3.4
Date: January 2025
Authors: René Weber, Hannes Heckel

Manufacturer Address
FAST LTA GmbH
Rüdesheimer Straße 11
D-80686 Munich
Germany
Phone: +49 (0) 89-89047-0
Fax: +49 (0) 89-89047-890
E-Mail:info@fast-lta.de
Internet:http://www.fast-lta.de
WEEE Reg. No. DE 78334839
FAST LTA Support
If the reference manual does not provide sufficient information, if there are difficulties with the configuration, or if there are further issues, please contact FAST LTA Support.
FAST LTA Support:
Weekdays Mon-Fri, 9 AM - 5 PM
Tel.: +49-89-890 47-772
E-Mail:lta-support@fast-lta.de
24/7 customers should contact the contacts specified in the maintenance contract
Design features of warning notices
This notice contains important additional information
This notice warns of a dangerous situation where non-compliance with the warning may lead to injuries. Follow the warning to avoid injuries.
This notice warns of a dangerous situation where failure to heed the warning may result in property damage. Follow the warning to avoid property damage.
Basic Safety Instructions
WARNING
Risk of injury due to electrostatic discharge
Always use an anti-static wrist strap with a grounding connection or an anti-static mat with a grounding cable when working on the Silent Cube System.
Crush hazard from falling loads
Always handle the device and its components with two people.
The device may only be opened by qualified personnel.
The device must be connected to a grounded power outlet.
Ensure easy access to the power outlets.

Risk of electric shock

To disconnect the power supply, all power sources must be separated to avoid the risk of electric shock.
Terms of Service
In order to ensure proper operation of the devices, the following conditions must be met:
The installation site must be dry and free of dust.
The optimal air temperature at the installation site is between +15°C and +25°C.
The air temperature at the installation site should not exceed 38°C.
The relative humidity at the installation site should not exceed 65%.
The system must not be operated at altitudes above 2000 meters above sea level.
If the components are installed in a rack that can also accommodate other units, the temperature in the rack may rise higher than the ambient temperature and may therefore exceed the maximum allowable ambient temperature for the components. Ensure that none of the ventilation openings are covered after installation to allow for adequate air circulation.
The mechanical seating elements within the frame must be designed to support the weight of the components.
Do not overload the electrical connections to the power supply. Please refer to the technical specifications in the manual.
Reliable grounding must always be ensured. Please note that the integration of multiple components may lead to an aggregation of the respective leakage currents, which can result in an unacceptably high leakage current (e.g., when a component is installed in a Rack that can also accommodate additional units).
Under no circumstances attempt to repair the long-term storage system yourself and do not remove the seals on the Head Unit and Storage Unit, as this will void the manufacturer's warranty. All maintenance work for these components is carried out by the FAST LTA Support Team as part of your maintenance contract.
Your Silent Cubes long-term storage
Welcome to the installation manual for your Silent Cubes and the Head Unit.
This installation manual complements the printed Quick Install that accompanies your Head Unit and guides you through the basic steps of a simple Silent Cubes installation. The manual consists of the following parts:
Preliminary Considerations | Retention Date, Volume Types | Part A: Preliminary Considerations |
General Setup | Wiring, Network Connection | Part B: |
Compliance Option | Enter License | Part B: |
Activate System | Temporary and Permanent License | Part B: Chapter 3 |
Configure System | Interface of the Cube Manager, System Settings, Volumes, and Approvals | Part C: |