Installation of the G-Series Controller

Mount rack rails

Disassemble rack rails

The rack rails must first be disassembled into two parts. Proceed as follows:

• ➤ Pull the inner rail out of the outer rail until the release lever (32) is visible.

Fig.: Pulling out inner rack rails

• ➤ Engage the release lever (32).

• ➤ Pull the inner rail fully out of the outer rail.

Fig.: Release lever

Mounting the Inner Rack Rails on the Controller/Shelf

To mount the inner rack rails on the controller/shelf, proceed as follows:

• ➤ Position the inner rack rail onto the side housing of the controller/shelf so that the locking pegs of the controller/shelf engage the locking holes of the rail.

• ➤ Slide the rail forward until it locks into place.

• ➤ Secure the rails on both sides to the housing with one of the enclosed M4×4 screws each.

Mounting the outer rack rails in the rack

• ➤ To mount the outer rack rails in the rack, proceed as follows:

• ➤ Slide the security mechanism (33) of the rail backwards.

• ➤ Hook the rail into the rack.

• ➤ Release the security mechanism.

• ➤ Ensure that the rectangular locking pins are correctly anchored in the rack holes.

• ➤ Screw the rack rail to the front side of the rack using the locking peg.

• ➤ Fasten the rack rail at the rear of the rack using the locking screw.

Insert controller/Shelf into rack

To insert a controller or a Shelf into a rack, proceed as follows:

• ➤ Pull the outer rack rails out of the rack as far as possible.

• ➤ Hang the device so that the inner rack rails slide into the outer rack rails.

• ➤ Push the device into the rack until it stops.

• ➤ Operate the release lever.

• ➤ Push the device into the rack until the locking mechanism engages.

Fig.: Locking Mechanism